17MM FET DRIVER

By default, the driver has two mode groups built in. The board uses a PIC microprocessor and has eight possible mode groups with optional memory of last mode depending on how you solder certain contacts. Choose your own mode levels. Number of light levels: This is the second most popular option.

Uploader:	Kazizragore
Date Added:	20 March 2016
File Size:	13.59 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	88699
Price:	Free* [*Free Regsitration Required]

WTS Texas Avenger 17mm FET plus *6+1 |

This momentary switch firmware gives you awesome ramping control, thermal throttling, and a slew of other features. The other are the Attiny version that you want. Ok, the idea with these drivers is that I can order them from OSHpark and keep them on hand for any build I may desire.

The 17m will blink to recognize the mode group change.

FET + Driver - 17mm - MTNDDm

Navigation menu Personal tools Create account Log in. We design, assemble, and test these drivers in-house in the USA using the best components available for the job. Crescendo is an awesome clicky ramping firmware with thermal control, among many other awesome features.

Also note that the cart includes both and OTC caps, you can remove one if you desire. This is the newest update of the guppydrv series by DrJones, now fett more modes than ever and thermal protection! To set the turbo timer: Retrieved from " http: This means the 8-chip driver is a 3. By default, the driver has two mode groups built in. Once it starts to cet, you are in configuration mode.

For use with more than 1 lithium cell on the input. Choose your own mode levels. The light will begin to ramp down power at around 9V under load.

Standard Clicky Firmware Options. Memory can be enabled via the configuraiton mode.

Help with MTN 17mm FET+7135 Driver

The light will then blink twice, pause, then blink twice again. This page was last edited on 31 Januaryat One side of the switch is soldered to ground, the other to the pre-tinned switch pad on the driver connected to pin 2.

Firmware from this source fwt be updated from time-to-time and may differ slightly from what you receive on your driver. Only the half assembled driver is left. To select mode group 3, tap the switch 8 times quickly to enter programming mode.

Turbo Timer A turbo timer may help reduce the chance of overheating. To switch mode groups: A turbo timer may help reduce the chance of overheating. Why buy this driver? You can fit on the pads if you are careful but if ordering new components, might as well go with With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode.

For a complete list of drivers, definitely check out the flashlight driver database and this CPF thread.

Popular drivers

The FET is obviously for turbo and works great at getting the most lumens possible. This driver gives you the best of both worlds: A turbo timer may help reduce the chance of overheating. The same can be done in reverse, you can put on the pads.