MOATES FLASH AND BURN DRIVER
Uploader: | Fauzragore |
Date Added: | 21 April 2006 |
File Size: | 17.28 Mb |
Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
Downloads: | 55619 |
Price: | Free* [*Free Regsitration Required] |
One cable needed and it's included in the bundle. These settings are important because most of the chips used in ECUs are a smaller capacity than the chip you are programming. While you are under the 'advanced' tab, make buurn the 'Latency' is set to '1' and not '16'.
Using the Flash & Burn
It reads the chip contents from the specified "Chip Addressing" fields and places them at the beginning of the buffer. I opened the box to find everything Bubbled wrapped to perfection. We will be selecting the correct buffer and chip addressing to ensure the chip is burned properly and can be used.
Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional. For more information, see "Advanced Addressing". Blank Check - This will check the entire chip and return success if the chip is blank, or failure if the chip is not blank or upon error.
He walked me through all these steps as I wrote for you. If you see this instead: Some adapters have chips which can hold more tunes than there are address lines for switching. It should be noted that this will erase the entire chip.
The chip gets read into the buffer, then the buffer gets saved to file. Erase Sector F only - This will erase an individual 64kbyte sector of a 29F Re-erase and blank check it. The New Hardware Found prompt should pop up and then go through the wizard, but when you get to the prompt where you can change to where the file is located, select the folder where you unzipped the usb files and let it finish installation.
This action makes use of the Buffer Addressing fields.
If the chip you flassh programming is of a larger capacity than the binary file you are putting on it, you need to use an offset to ensure the tune ends up in the right spot on the chip.
Go to control panel and open the system icon. Current time is 9: If your burner fails to erase several different chips, you probably have fake chips.
Load File To Buffer - Pressing this button will bring up an expolorer dialog to select a file with which to fill the buffer. After all the stuff is done, you are now finally ready to open TunerPro or the standalone Flash-N-Burn program. Failing blank checks is moares common sign of fake chips.
Flash & Burn Program for BURN1/2/Jaybird+APU1
Must program using EEC Editor. Rlash that happens then you have successfully setup the chip burner and software and ready to burn you some chips.
Programming chips with offsets comes into play in two situations: Make sure motes says device enable, then click port settings tab, then click the advanced button located in the middle.
It makes use of the current buffer and burns the chip from the data in the buffer specified in the "Buffer Addressing" fields and burns the information to the chip at the location specified in the "Chip Addressing" fields. Try another chip purchased from us, xenocron.
Reading a chip To File - To read a chip to a file: The next step is to load the file you want to program to the chip. I just want to thank Luti for all his freaking help. Switching adapters use chips that are larger than an ECU requires, allowing the extra space to be used for multiple programs. Save Buffer To File - This button will allow you to save the contents of the buffer to a file. Install the chip per directions printed on the burner — the unused pins should be closest to the nurn handle.
Comments
Post a Comment